Transmitter Programming - EMS 7940 IRIS+ Installation And Programming Instructions

EMS 7000 IRIS +

5. Transmitter Programming

5.1 The transmitter unit has the facility of changing it's inputs orientation and also the
unique identity code for the transmitter can be programmed. The settings for the
transmitter are as follows with the menu commands required shown in brackets:-
Inputs unique identification code (ID). Orientation of the input to normally open
or normally closed (CON).
operation of the inputs is described in more detail in the following paragraphs
under their menu commands headings.
5.2 To allow access into the programming menu the computer should be set up with
Windows HyperTerminal as follows:-
PLEASE NOTE: Examples shown below are from Windows XP. Other
versions of Windows may vary.
To start a new HyperTerminal session, click on the 'Start' button.
Then select 'Programs' and then 'Accessories'.
Now select 'Communications', then 'HyperTerminal'.
You will then be presented with the following screen: -
A full explanation of the input settings and the
7
7940 ENGINEERS GUIDE v2.2 – 13/04/10