Operation - Sennheiser e 908 Instruction Manual

e908_Manual_01_2019_EN.indd 5

Operation

Positioning the microphone e 908 B/e 908 B ew on a wind instrument
Use the microphone clamp to attach the e 908 to the bell of the instrument.
It is vital to observe the following notes:
Position Resulting sound
A Reduced ambient noise
B Clear, powerful sound
C Balanced, natural sound
A
Positioning the microphone e 908 D on a drum
Attach the drum clamp to the rim of the drum by putting the upper part of the clip onto the rim
and clipping it on by pushing down the drum clamp in a rotating action until it snaps into place.
Loosen the knurled screw.
Insert the gooseneck from the side into one of the two slots.
Tighten the knurled screw.
It is vital to observe the following notes:
Position Resulting sound
D More fundamental
Little overtones
E Less fundamental
Many overtones
F Pronounced proximity effect
D
You can attach two microphones to the drum clamp (e.g. for picking up two toms in cramped space
conditions). To do so, use both slots of the drum clamp.
The various adjustment possibilities of the MZH 9 08 D and MZH 9 08 B clamps together with the
flexible gooseneck enable the microphone to be optimally positioned on the sound source.
Commentary
Directed into the bell of the instrument.
Directed partly towards the bell and partly towards
the body of the instrument.
B
Commentary
Position on the drum: 3–5 c m above the drumskin,
directed towards the center of the drumskin, the
fundamental to overtones ratio can be adjusted by
changing the angle of the microphone.
The most balanced results are obtained at an angle
of 30–60°.
Optional: tangential position of the gooseneck in
order to reduce the distance to the drumskin.
E
Operation
C
F
e 908 | 5/8
26.02.2019 13:58:53