Tank Filling - Life Fitness Row GX Owner's Manual

Tank Filling

CAUTION: Use a drop cloth under the tank when filling to avoid staining floor or carpet.
Remove yellow plug only for filling. Fill with adjuster
handle at level 16 only.
Once filling is complete, use a coin or large blade
screwdriver to tighten tank plug into place.
WARNING: Do not insert fingers into tank!
1. Filling requires a large bucket (not supplied) and the Fluid Rower Siphon (included). Filling will take approximately
7.6 liters of water.
2. Unscrew the right tank plug on tank back and insert the flexible tube into the rear of the tank while keeping the rigid
hose in the bucket.
NOTE: The siphon tube may be impeded by one of the impeller blades. Use the siphon only to push the
impeller down slightly.
NOTE: Where water quality is known to be poor, Life Fitness recommends the use of distilled water.
3. Move the adjuster handle to level 16, and begin filling. Do not fill past the calibration mark indicated on the tank!
NOTE: The siphon valve must be closed to allow siphoning action to occur.
NOTE: Placing the bucket in an elevated position will allow the siphon to continually pump water into the
tank.
NOTE: Opening the siphon valve will stop the pumping action. Use this feature to avoid water spillage when
nearing filling completion.
4. Once filling is complete (to the proper calibration level as indicated on the tank), follow water treatment schedule
as shown.
NOTE: The lower tank plug is permanently sealed.
Page 8 of 18