Auto Image Adjustment - EFI IQ-501 How To Use Manual

How-To: Using the IQ-501 with the Fiery server

Auto Image Adjustment

or Real time adjustment
RGB/Process K strips
The engine keeps track of which set of strips were
last printed and ensures that they alternate.
Position markers shown in red circles.
1. Open Job Properties of the job in which you
2. Select the Image tab.
3. Pull down the Color Gradation section
4. Select either Position or Position+Gradation.
5. OPTIONAL: check the Color gradation patch
6. Click OK.
7. Print the job.
8. Follow directions as needed on the Press Control
CMYK strips
4
wish to engage Auto Image Adjustment.
Note that on some software versions the Auto
Image Adjustment may be in the Job Info tab or
directly under the Image tab
or Realtime Adjustment section.
position check box and choose a +/- Shift value
to fine tune the placement of the color bars on
the edge of the sheet.
Panel.
For the Position+Gradation selection the engine
places alternating CMYK and RGB/Process K
strips on the sheets' inboard and outboard edges.
Approximately 9mm per edge is used. Position
places cross hair marks within the 9mm edge at
each corner. Please ensure that user content is
not placed in these border areas as the engine will
override and knock out content.
Note: ImageViewer or Preview will not show these
marks as they are added at the engine.
Note2: If the position marks or color bar strips do
not appear please contact Konica Minolta service
in order to resolve.