Safety Instructions - Kushlan 600 Series Operating Instructions Manual

For the safety of yourself and others around you, it is extremely
1. Keep hands and clothing away from moving parts at all times.
2. Do not operate this machine under the influence of alcohol or while taking medication that impairs
the senses or reactions.
3. Make certain that the work area around the machine is clear of debris and obstructions.
4. Keep all unauthorized and untrained people away from the machine at all times.
5. Never let the mixer run unattended even for a brief moment.
6. Turn off the motor when you leave the machine.
7. Only use or operate the mixer on level ground to prevent the mixer from tipping over.
8. Do not abuse the power cord; i.e. Never yank on the cord to disconnect it. Keep the cord away
from heat, oil, and sharp edges.
9. Do not over reach while working with the mixer. Keep proper footing and balance at all times when
loading or unloading the mixer.
10. Never allow children or inexperienced operators to operate or repair the mixer.
11. Use only factory authorized parts for replacement.
12. Keep these operation instructions with the machine at all times.
13. Always wear safety glasses and safety shoes when operating and moving equipment.
A. Lubrication: There are grease fittings (item 23) on all models. Apply any type of multipurpose
grease until grease begins to come out of the bushings in housing and bearings on wheels.
B. Extension Cord: Use only outdoor approved, 14 gauge or larger, grounded extension cords.
C. Gear Adjustment: If the gear on the jackshaft (item 9) is not meshing properly with the ring gear and
plate(14), adjustment can be made by loosening the whizlock screws and attaching the jackshaft
housing (10) and sliding the housing tube until proper alignment is obtained. If removal of pulley
guard is necessary, make certain it is reattached to the machine before using.
D. General: Check all screws for tightness before each use.
E. Motor Adjustment/Belt Tensioning: To adjust belt tension, loosen the four screws that attach the
motor to the frame. Make adjustments and retighten screws. V-belt tensioning should be retightened
after the first 20 hours of use. The belt should be tightened until the belt deflects approximately 1/4"
with regular thumb pressure. Replace covers and guards before using the machine.
F. Concrete Mixing: Do not insert sharp objects into the plastic mixing drum. Doing so will damage the
drum.
G. Cleaning: Do not spray water on or into the motor. Thorough cleaning of the mixer after each use is
recommended and will add to the service life.

SAFETY INSTRUCTIONS

important that you observe the following notes.
Mixer Instructions
2