Electrolux ERN3003FOW User Manual page 33

Problem
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
Upper or lower
square is shown in
the temperature dis-
play.
Possible cause
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
An error has occurred in
measuring the tempera-
ture
ENGLISH
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the food temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
This is correct.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
33