Flex XFE 15 15018.0-EC User Manual page 20

XFE 15 150 18.0-EC
NOTE
Use original FLEX accessories on this
model. Not using original FLEX accessories
may lead to a poor polishing result,
increased vibrations and also greater wear
or even damage to the power tool.
Information concerning foam wear
NOTE
In general, foam wear is much higher in
connection with free-wheeling eccentric
polishing that with rotational polishing or force-
driven eccentric polishing.
Due to the drive, this wear does not take
place on the outside of the foam but at the
foam core instead. The harder/longer the
cell structure is subjected to strain and
damaged as a result, the faster the build-up
of heat. Subsequent damage is inevitable.
Wear of this kind cannot be seen on the foam
externally. The only reliable action is
replacement and disposal in good time to
prevent thermal damage to the power tool.
Switch on and off
Brief operation without engaged switch
rocker
Press and hold down the switch.

To switch off, release the switch.

Continuous operation with engaged
switch rocker
Switching off/removing the rechargeable
battery
– Switch off the electric power tool.
– Switch on the electric power tool again.
Press and hold down the switch (1.).

To lock into position, hold down the

locking button (2.) and release the
switch.
To switch off, briefly press and release

the switch.
Preselecting the speed
To set the operating speed, move the dial

to the required value.
Gently press the switch to accelerate the

power tool up to the preselected speed.
21