Hydro Troubleshooting; Hydraulic Pump Belt Installation; Replacement Parts; Mower Speed Control Ranges - Snapper SP360 Safety Instructions & Operator's Manual

SECTION 4 - SERVICE
4.2.3. HYDRAULIC PUMP REMOVAL (Continued)
2. Loosen Nut on Belt Guide at rear of Engine Pulley
and remove Cutter Deck Belt from Engine Pulley.
3. Remove Hydraulic Pump Belt.

4.2.4. HYDRAULIC PUMP BELT INSTALLATION

1. STOP ENGINE! Place Hydraulic Belt on Engine and
Pump Pulleys.
2. Attach Idler Spring to Bolt and reattach Nut to Bolt.
3. Place Cutter Deck Belt on Engine Pulley.

4.2.5. REPLACEMENT PARTS

To retain the quality of your Machine, use genuine
SNAPPER replacement parts only. Contact your local
SNAPPER Dealer for parts and service and service
assistance. For the correct part or information for your
Machine, always mention Model and Serial Number of
Power Unit and mower Attachment.
returning your Machine to an authorized SNAPPER
Dealer on a yearly basis for inspection and addition of
any new devices which might upgrade the performance
and SAFETY of your Machine.
SNAPPER Dealer, check the yellow pages under the
heading, LAWN MOWERS.
Service, look for the Engine Manufacturer's Dealers
under the heading, ENGINES - GASOLINE.
WARNING
Before performing service on machine, turn Ignition
Key to STOP, close fuel shut-off valve, and allow
engine to cool. Disconnect spark plug(s) if machine
is to be raised or tilted. Make sure to secure machine
in place to prevent it from falling.
NOTE: All Mid-Size Machines should be tilted with
Engine Carburetor side UP.
We recommend
For the nearest
For Engine Parts and
4.3 MACHINE SPEED CONTROL RANGES
4.3.1. TO CHANGE MACHINE SPEED RANGES
1. Move Traction Control Levers and Neutral Latch
Lever into neutral.
2. Turn Key to STOP position and remove Key from
Ignition Switch.
3. Remove Hairpins from Swivels on Traction Control
Arms on Right and Left Hand side.
4. Push Swivel out from each Traction Control Arm and
insert Swivel into newly selected speed range. (No
adjustment should be necessary to maintain neutral
setting after changing speed range.)
5. Start the Engine and resume using the Machine at the
newly selected speed range. See Figure 4.5.
MEDIUM SPEED
0 - 4.2 MPH
LOW SPEED
0 - 2.5 MPH
SELF LOCK
COTTER PIN
20
HIGH SPEED
0 - 6 MPH
SWIVEL
TRACTION
CONTROL
ROD
TRACTION CONTROL ARM
FIGURE 4.5