Canon iR1210 Service Bulletin page 101

iR1210/iR1230/iR1270F
Model:
iR1200/iR1300 Series SERVICE MANUAL (Rev.0) (FY8-13HU-000)
Location:
Correction of " R emoving Image Processor PCB " .
Subject:
Correction of the Service Manual
Reason:
Detail:
The description is corrected shown in 2.2.1 "Removing the Image Processor PCB" in Chapter 5 of the Service
Manual as follows.
<Before correction>
1) Remove the rear cover. (See 2.1.1.1)
2) Remove the printer controller PCB. (See 2.2.5)
3) Remove the retainer for the flexible cable used to connect the analog processor PCB and the image
processor PCB.
4) Remove the core, and disconnect all connectors from the image processor PCB [1].
5) Remove the 6 screws [2], and detach the image processor PCB [1].
Caution: For installation, fasten the core to the upper position with the part [3] and fix the cable with the
part [4].
<After correction>
1) Remove the rear cover. (See 2.1.1.1)
2) Remove the Printer controller PCB. (See 2.2.5)
3) Remove the right cover. (See 2.1.1.2)
4) Remove the screw [1], and detach the ADF harness cover [2].
F05-202-01A
5) Remove the 2 harness retainers [3].
6) Remove the screw [4] and disconnect the grounding wire from the core.
7) Disconnect the 2 connectors (J310/J311) [5].
F202-01B
8) Pull both connectors (J310/J311) [5], through the upper cover [6].
F202-01C
9) Remove the retainer [7] for the flexible cable used to connect the analog processor PCB and the image
processor PCB.
Service Bulletin
Issued by Canon Europa N.V.
COPIER
No.: iR1200S-009
(FF-T01-L6-000063-01)
20.12.02
DATE:
-
1 / 2 -