Wheel Drive; Cutting Height Adjustment - Snapper SERIES 16 250816B Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
2.4.4.
PARK BRAKE (Continued)
2. Release park brake by pushing down on the
Clutch/Brake Pedal to release park brake lever. See
Figure 2.15.
PUSH CLUTCWBRAKE
PEDAL ALL THE \
\
WAY DOWN
2.4.6. WHEEL DRIVE
1. With engine running, adjust engine speed con-
trol to "FAST" position.
2. Depress Clutch/Brake Pedal.
3. Place transmission shift lever in the notch for
the desired speed.
4. Release Clutch/Brake Pedal to start desired di-
rection.
5. During forward motion, the transmission shift
lever may be placed in any desired forward speed
without depressing the Clutch/Brake Pedal.
NOTE: For best cutting results, move the transmission
shift lever into a slow forward speed and the engine speed
control to a fast position. This combination will allow the
mower blades to lift the grass while cutting smoothly and
evenly.
A WARNING
Never park the Rear Engine Rider on an
incline or embankment.
2.4.5.
FIGURE 2.15
CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any one of
six positions using deck lift lever. When in
desired height of cut, release latch, then try to
move deck lift lever to ensure lift lever latch is fully
engaged. See Figure 2.16.
DECK
LIFT
LEVER
FIGURE 2.16
8