Lift Group - Manual Lift 985894 NOTE: Unless noted otherwise, use the standard hardware torque specification chart. Torque to 23-28 ft. lbs. (31-38 Nm) Rotate clockwise as far as possible before tighting. Assemble into lower hole of Ref. Item 20. The above parts group applies to the following Mfg.
Electrical Group NOTE: Unless noted otherwise, use the standard hardware torque specification chart. HOOD MOUNTED UNDER HOOD Tie main harness and starter wire up. Wires should not hang below side panel with hood closed. To Electric Clutch To Charge Circuit To Fuel Shut-Off To Oil...
Page 32
Electrical Group NOTE: Unless noted otherwise, use the standard hardware torque specification chart. HOOD MOUNTED UNDER HOOD Tie main harness and starter wire up. Wires should not hang below side panel with hood closed. To Electric Clutch To Charge Circuit To Fuel Shut-Off To Oil...
44" & 50" Mower Deck - Clutch & Support NOTE: Unless noted otherwise, use the standard hardware torque specification chart. Engine Pulley Arbor Drive Pulley Arbor Drive Idler Pulley Pulley Insert Must Face Out The above parts group applies to the following Mfg. Nos.: 1694371 - 44"...
44" & 50" Mower Decks - Housing, Arbors & Blades NOTE: Unless noted otherwise, use the standard hardware torque specification chart. Apply gasket former to this surface if foam gasket is not used. Fill arbors with multipurpose grease after gasket former has cured. The above parts group applies to the following Mfg.
Page 48
44" & 50" Mower Decks - Housing, Arbors & Blades NOTE: Unless noted otherwise, use the standard hardware torque specification chart. Apply gasket former to this surface if foam gasket is not used. Fill arbors with multipurpose grease after gasket former has cured. The above parts group applies to the following Mfg.
Hardware Identification & Torque Specifications Common Hardware Types Hex Head Capscrew Carriage Bolt Standard Hardware Sizing When a washer or nut is identified as 1/2”, this is the Nominal size , meaning the inside diameter is 1/2 inch; if a second number is present it represent the threads per inch When bolt or capscrew is identified as 1/2 - 16 x 2”, this means the Nominal size , or body diameter is 1/2 inch;...