Starting & Stopping Wheel Drive; Setting Cutting Height - Snapper CLP21650RV Safety Instructions And Operator's Manual

OPERATING INSTRUCTIONS
ii i i r iiii i
TO
STARTING WHEEL DRIVE
Start engine.
Move ground speed control lever to desired forward
speed. See Figure 10.
Pull wheel drive control to handle bar and hold. See
Figure 10.
I!! !i!i !ii ii!i iii!i il ll!iiii i!ii! iiii !ii]
DO NOT attempt to change forward speed while the
mower is in motion. Release the wheel drive control,
then move the ground speed control to the desired
speed.
WHEEL
DRIVE
CONTROL
STOPPING WHEEL DRIVE
Release the wheel drive control. See Figure 10.
Stop engine by releasing blade/engine control. See Fig-
ure 10.
ADJUSTING
HANDLE
FIGURE 10
Remove spark plug wire from spark plug and secure
wire away from plug.
Move to right rear tire and pull adjusting handle out until
adjusting handle tab is just clear of the slotted plate.
See Figure 11.
IMPORTANT: DO NOT flex the adjusting handle
outward beyond what is required to change cutting
height. Pulling out to far may cause damage to the
handle.
LOW
CUT
i
BLADE
CONTROL
STOP
1SPEED
SPEED
3SPEED
GROUND
SPEED
CONTROL
HIGH
CUT
Move the adjusting handle towards front of mower for
higher cut or toward rear for lower cut. See Figure 11.
The SNAPPER Walk Behind Mower has six cutting
positions ranging from 1" to 4". See Figure 12.
Reinstall spark plug wire onto spark plug and start the
engine to resume mowing.
1"
1-518"
FIGURE 11
2-718"
2-1/4"
FIGURE 12
3-7/16"
4_
illll i iii i i _ i
9