Set Up The Network Connection - Primex Wireless SNS2TPS-2 Installation Manual

Configure Sensors for the Network
Configuring AC-powered Sensors Using Discovery and Auto-Configuration (Same Subnet as
the AMP)
1. Connect the temperature probe to the sensor in the available Sensor Probe jack.
2. Connect one end of the Ethernet cable to the RJ45 port on the side of the sensor device, as
shown in Figure 2. Connect the other end of the Ethernet cable to the network on the same
subnet as the AMP.
3. Plug the AC adapter for the sensor device into a power source.
4. Plug the AC adapter into the sensor device. The sensor device will display all the segments
and then go blank briefly before displaying the temperature.
5. When the sensor display shows the temperature, push and immediately release the button
on the front of the sensor. The sensor will emit a series of beeps. The beeps signal the
following connection sequence: 1= radio booted, 2 = connected to network, 3 = connected to
the AMP.
6. Check the AMP to confirm that the sensor device has checked in. The sensor device
appears in the Sensor Devices list with the MAC address in brackets in the Name column.
Double-click on the sensor device in the Sensor Devices list to edit information for the
sensor, for example, change the name to something meaningful. Refer to the SNS
Temperature and Humidity Sensors User Guide for details on editing sensor device
information on the AMP.
7. Disconnect the Ethernet cable from the sensor.
8. The Sensor Default Profile is stored in the sensor's non-volatile memory, so you can unplug
and move the sensor device to its installation location.
Note: Verify that the first sensor device you configure checks in with the AMP with the
correct settings before configuring additional sensors. The first sensor device
does not check in or the settings are not correct, troubleshoot the problem or
correct the default profile before configuring additional sensors.

Set up the Network Connection

During Browser-based Configuration, the AC-powered sensor device must communicate with your
computer. Follow these steps to prepare your computer to communicate AC-powered sensor
devices.
Setting up the Network Connection
1. From the Windows Start button, select Settings>Control Panel>Network Connections. A
Network Connections window, similar to Figure 15, opens with LAN or High-Speed Internet
information.
Primex Wireless, Inc. SNS™ Temperature and Humidity Sensors Installation Guide
Set up the Network Connection
32