KUHN GA 8001 H Assembly And Operators Manual page 26

12. Fitting tine arms and tines (fig. 9)
- First fit tine arms (1) on supports (2) by means of of linchpins (3).
- Connect small hook of cord (4) to the ring of linchpin (3) then attach the larger hook of cord (4) to hole (5) of
tine arm lug.
- Next fit supports (2) with tine arms (1) on the gearbox oscillating shafts (6) by means of roll pins (8)
(diameter 12 x 55) and (7) (diameter 7 x 55).
Attention : The right and left-hand rotor arms are symetrically curved to one another. Ensure they are
positioned so that the curved portion is facing the front as seen in the direction of rotation
(see arrows figure 9).
.
Attention : Make sure slots in pins (7) and (8) are opposite to one another in the direction of the main effort
(see drawing on figure 9).
Clean and grease disconnectable tine arm stubs (1) regularly with a “never-seize”
compound.
- Attach tines (9) under tine arms (1) so that they face in the direction opposite rotor rotation indicated by the
arrow.
- To fit the tine arms use :
. 1 hexagonal bolt (10) (M 12 x 75)
. 1 flat washer (11) (diameter 13 x 35 x 7)
. 1 tine bracket (12)
. 1 spring washer (13)
. 1 self-locking nut (14)
Make sure these parts are positioned correctly.
- 24 -