Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for KUHN GA 4311 GM
Summary of Contents for KUHN GA 4311 GM
- Page 1 ASSEMBLY / OPERATOR'S MANUAL GA 4311 GM GYRORAKE N° 95315 A.GB - 07.98...
-
Page 2: Dear Owner
DEAR OWNER, In buying a KUHN machine you have chosen wisely. Into it have gone years of thought, research and improvements. You will find, as have thousands of owners all over the world, that you have the best that engineering skill and actual field testing can produce. You have purchased a dependable machine, but only by proper care and operation can you expect to receive the performance and long service built into it. - Page 3 CONTENTS Page...
-
Page 4: Designated Use Of The Machine
SAFETY DESIGNATED USE OF THE MACHINE GA 4311 GM GA 4311 GM... -
Page 5: General Safety Recommendations
GENERAL SAFETY RECOMMENDATIONS BASIC PRINCIPLES... - Page 6 ATTACHMENT...
-
Page 7: Power Take-Off
POWER TAKE-OFF... -
Page 8: Maintenance
TIRES MAINTENANCE... -
Page 9: Safety Decals
SAFETY DECALS... -
Page 11: Technical Specifications
TECHNICAL SPECIFICATIONS TYPE GA 4311 GM Special features GA 4311 GM... - Page 12 ASSEMBLY INSTRUCTIONS 1° FITTING FRONT AND REAR GUARD HINGES Do NOT tighten 2° FITTING GUARDS Now tighten the 8 hexagonal bolts (I) After assembly, make sure each safety guard locking system works correctly.
- Page 14 3° MOUNTING OF THE ROTOR LOCK CONNECTING RODS 4° FITTING SWATH SCREEN 5° FITTING TINES, TINE ARM HOLDERS AND TINE ARMS Fit the tine arms (A) onto the oscillating shafts making sure that the bent form of the arms faces forwards when looking in the direction of rotor rotation ATTENTION Clean and regularly apply a "Never Seize"...
-
Page 16: Fitting To The Tractor
ATTACHMENT 1° FITTING TO THE TRACTOR GA 4311 GM 2° PTO SHAFT to the 540 rpm tractor drive Never connect the PTO to the 1000 rpm tractor drive. To avoid accidents which could be serious, make sure that the guards are always correctly in place and secured with the safety chains provided (photo 10). - Page 18 WORK POSITION - ADJUSTMENTS BEFORE CARRYING OUT ANY OPERATION SUCH AS MAINTENANCE OR ADJUSTMENT ON THE MACHINE, STOP THE TRACTOR ENGINE, REMOVE IGNITION KEY AND WAIT FOR THE ROTOR TO STOP BEFORE LEAVING THE TRACTOR. 1° WHEEL HEIGHT ADJUSTMENT : NOTE 2°...
-
Page 20: Operation
OPERATION GA 4311 GM 1° Poor raking with hay left in the centre (fig. 23) 2° Poor raking at sides (fig. 24) FORWARD SPEED... - Page 22 BEFORE GOING ON THE ROAD, CHECK THAT THE LIGHTING EQUIPMENT AND REFLECTORS ARE CLEAN AND OPERATE WELL. NEVER ENGAGE THE ROTOR DRIVE WHEN THE MACHINE IS IN THE TRANSPORT POSITION (ROTOR LOCKED). PARKING ALWAYS PARK THE GA 4311 GM ON A FLAT AN NEARLY EVEN SOIL. Note...
- Page 24 LUBRICATION BEFORE CARRYING OUT ANY OPERATION SUCH AS MAINTENANCE OR ADJUSTMENT ON THE MACHINE, STOP THE TRACTOR ENGINE, REMOVE IGNITION KEY AND WAIT FOR THE ROTOR TO STOP BEFORE LEAVING THE TRACTOR. - Every 8 hours - Every 50 hours Note Regularly clean and apply a “Never-Seize”...
-
Page 26: Optional Accessories
OPTIONAL ACCESSORIES 1° WARNING BOARD AND LIGHT KIT (No. 113 6300 + No. 113 6350) NOTE... - Page 28 2° BOGIE AXLE Kit no. 113 6180 ALWAYS ENSURE THAT BOTH WHEEL AXLES ARE ADJUSTED TO THE SAME HEIGHT.
-
Page 30: Front Support Wheel
3° FRONT SUPPORT WHEEL Kit no. 113 6360 After assembly, always check the 3-point frame can move freely. Height of wheel Adjustment is correct At work At transport do not forget... -
Page 32: Troubleshooting Guide
TROUBLE SHOOTING GUIDE Problem Possible cause Remedy... -
Page 33: Sound Levels
SOUND LEVELS Sound levels given out by : GA 4311 GM Gyrorake Sound levels have been measured in accordance with the measuring methods as defined in : HM Agricultural Inspectorate AGRICULTURAL MACHINERY NOISE Legislation and guidance on methods of testing... -
Page 34: Limited Warranty
LIMITED WARRANTY KUHN S.A. THESE CONDITIONS ARE SUBJECT TO THE FOLLOWING EXCEPTIONS : THE CUSTOMER WILL BE RESPONSIBLE FOR AND BEAR THE COSTS OF:... - Page 35 LIMITED WARRANTY IS DEPENDENT UPON THE STRICT OBSERVANCE BY THE PURCHASER OF THE FOLLOWING PROVISIONS : DISCLAIMER OF FURTHER WARRANTY There are no warranties, expressed or implied, except as set forth above. There is no warranty of merchantability. There are no warranties which extend beyond the description of the product contained herein.
- Page 36 - N O T E S -...
- Page 39 This machine complies with the safety requirements of the European machinery directive. The Operator should respect all Health and Safety regulations as well as the Highway Code. For your own safety, use only genuine KUHN spare parts. The manufacturer disclaims all responsibilities due to incorrect use or non-compliance with the...
- Page 40 KUHN parts KUHN S.A. 4 Impasse des Fabriques F - 67706 SAVERNE CEDEX Tél. : + 33 (0) 3 88 01 81 00 - Fax : + 33 (0) 3 88 01 81 03 www.kuhnsa.com - E-mail : info@kuhnsa.com...
Need help?
Do you have a question about the GA 4311 GM and is the answer not in the manual?
Questions and answers