Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for KUHN GA 4511 GM
Summary of Contents for KUHN GA 4511 GM
- Page 1 ASSEMBLY / OPERATOR'S MANUAL GA 4511 GM GYRORAKE N° 95314 B.GB - 07.98...
-
Page 2: Dear Owner
DEAR OWNER, In buying a KUHN machine you have chosen wisely. Into it have gone years of thought, research and improvements. You will find, as have thousands of owners all over the world, that you have the best that engineering skill and actual field testing can produce. You have purchased a dependable machine, but only by proper care and operation can you expect to receive the performance and long service built into it. - Page 3 CONTENTS Page...
-
Page 4: Designated Use Of The Machine
SAFETY DESIGNATED USE OF THE MACHINE GA 4511 GM GA 4511 GM... -
Page 5: General Safety Recommendations
GENERAL SAFETY RECOMMENDATIONS BASIC PRINCIPLES... - Page 6 ATTACHMENT...
- Page 7 POWER TAKE-OFF HYDRAULIC SYSTEM...
- Page 8 TIRES MAINTENANCE...
-
Page 9: Safety Decals
SAFETY DECALS... -
Page 11: Technical Specifications
TECHNICAL SPECIFICATIONS GA 4511 GM special features :... - Page 12 ASSEMBLY INSTRUCTIONS GA 4511 GM 1° Fitting the guard’s rear support and front hinges 2° Fitting the guards 3° Fitting the hydraulic cylinder and hoses...
- Page 14 NOTE NOTE Before putting the machine to work, extend and retract the hydraulic cylinder several times to bleed the circuit.
- Page 16 4° Fitting the warning boards and signalling elements rear left light marked “L” left board rear left light identified by a white white The locking tab (1) of the female connector (2) must be fully engaged over the peg (3) of the male connector (4) (fig. A). The locking tab (1) of the female connector (2) must be fully engaged over the peg (3) of the male connector (4) (fig.
- Page 18 ATTACHMENT 1° FITTING TO THE TRACTOR GA 4511 GM Note 2 ° PTO SHAFT to the 540 rpm tractor drive Never connect the PTO to the 1000 rpm tractor drive. To avoid accidents which could be serious, make sure that the guards are always correctly in place and secured with the safety chains provided.
- Page 20 WORK POSITION - ADJUSTMENTS GA 4511 GM Before carrying out any operation such as maintenance or adjustment on the machine, stop the tractor engine, remove ignition key and wait for the rotor to stop before leaving the tractor. Bogie Axle Height Adjustment :...
-
Page 22: Operation
OPERATION GA 4511 GM GA 4511 GM 1° Poor raking with hay left in the centre (fig. 13) 2° Poor raking at sides (fig. 14) FORWARD SPEED... - Page 24 TRANSPORT GA 4511 GM Clear all people away from the guard pivoting zone before putting the machine into the transport position. The parking stand must always be folded up in the horizontal position when in transport and in work. Never let the rotors rotate when the machine is in the transport position due to risks of accidents and material damage.
- Page 26 PARKING ALWAYS PARK THE MACHINE ON EVEN, FAIRLY LEVEL GROUND. GA 4511 GM...
- Page 28 LUBRICATION Note Regularly clean and apply a “Never-Seize” compound to the removable portion of the tine arms to ensure easy removal. Before carrying out any operation such as maintenance or adjustment on the machine, stop the tractor engine, remove ignition key and wait for the rotor to stop before leaving the tractor.
-
Page 30: Optional Accessories
OPTIONAL ACCESSORIES FRONT SUPPORT WHEEL Kit no. 113 6360 After assembly, always check the 3-point frame can move freely. Height of wheel Adjustment is correct At work At transport do not forget... -
Page 32: Electrical Connector (For North America)
ELECTRICAL CONNECTOR (for North America) -
Page 33: Sound Levels
SOUND LEVELS Sound levels given out by : GA 4511 GM Gyrorakes Sound levels have been measured in accordance with the measuring methods as defined in : HM Agricultural Inspectorate AGRICULTURAL MACHINERY NOISE Legislation and guidance on methods of testing... -
Page 34: Limited Warranty
LIMITED WARRANTY KUHN S.A. THESE CONDITIONS ARE SUBJECT TO THE FOLLOWING EXCEPTIONS : THE CUSTOMER WILL BE RESPONSIBLE FOR AND BEAR THE COSTS OF:... - Page 35 LIMITED WARRANTY IS DEPENDENT UPON THE STRICT OBSERVANCE BY THE PURCHASER OF THE FOLLOWING PROVISIONS : DISCLAIMER OF FURTHER WARRANTY There are no warranties, expressed or implied, except as set forth above. There is no warranty of merchantability. There are no warranties which extend beyond the description of the product contained herein.
- Page 36 - N O T E S -...
- Page 39 This machine complies with the safety requirements of the European machinery directive. The Operator should respect all Health and Safety regulations as well as the Highway Code. For your own safety, use only genuine KUHN spare parts. The manufacturer disclaims all responsibilities due to incorrect use or non-compliance with the...
- Page 40 KUHN parts KUHN S.A. 4 Impasse des Fabriques F - 67706 SAVERNE CEDEX Tél. : + 33 (0) 3 88 01 81 00 - Fax : + 33 (0) 3 88 01 81 03 www.kuhnsa.com - E-mail : info@kuhnsa.com...
Need help?
Do you have a question about the GA 4511 GM and is the answer not in the manual?
Questions and answers