Step1: Initial Command As the information showed on your screen, please enter these commands below to start your test. Command: 1 Wi-Fi testing mode Step2: Generate 802.11 b/g/n Packet (1)Command: 22 1 12 1 22: Initial transmit power in the antenna 1: Set the wanted channel (1~11 for B/G/N mode) 12: Set the wanted power, typically G mode: 25.05 dBm/ B mode: 21.26 dBm 1: Set the mode, 1_G mode &...
Step3: Generate 802.11b/g/n continuous symbol (1)Please re-type the Step5 (1)~(4) commands. (2)Command 17 1 13 17: Set continuous mode. 1: Enable data rate 13: 54 Mbps, other data rate, please refer the above table. After you type above command, you can measure the 802.11b/g continuous symbol in your RF test instrument.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.