SureCall TRIFLEX-2GO-T User Manual page 9

Step 2. Connect the Inside Antenna (Vehicle, Motorhome, and Desktop Installations)
1. Mount the inside antenna:
x Within 2-3 feet of the cell phone for best results.
x On a surface that is at least 4 inches (10cm) from metal
2. Using the supplied cable, connect the inside antenna to the booster connector
marked INSIDE (see page 5).
3. Hand tighten the connection.
Step 3. Mount the Booster (Optional for Vehicle Installations)
1. Select a location for your booster, such as under the driver's seat.
Step 4. Connect to DC Power
1. Connect the DC power cord to the booster before plugging it in to the cigarette
lighter adapter. Verify that all connections to the booster are tight and secure.
2. Turn the power switch on the lighter adapter to the ON position.
x The LED light glows, indicating that the booster is ready to use. The booster
turns on automatically.
x The Power LED goes ON to show that the booster is ready for use (see
page 5).
x If the Power LED does not go ON, be sure the DC outlet and adapter are
working.
If the red LED goes ON, it is the result of one or two factors:
1. More antenna separation is needed. Most likely, the easiest way to achieve
this is to move the magnetic mount antenna farther to the back of the vehicle
away from the inside patch antenna.
2. Your vehicle is too close to a cell tower.
SureCall TriFlex-2Go-T Multi-Use Kit Cellphone-Mate, Inc.
All rights reserved.
INSTALLATION
Page 9