Snapper P/N 7600026 Operator's Manual page 8

3
unit assembly
RAISE UNIT
HOOK CLAMSHELL
MOUNT ONTO
BUMPER MOUNT
PLATE PINS
SLIDE ROD
THROUGH
HOLES
MAKE SURE
BEND IS UP
BOLT ARM TO
INSIDE OF HANDLE
PUSH HANDLE
DOWN TO
LOCK COVER
STEP 13: Hook bottom of clamshell mount onto
pins in bottom of bumper mount plate, then raise
clamshell assembly up against bumper mount.
IMPORTANT:
installing clamshell unit.
STEP 14: Slide hitch rod through aligned holes in
clamshell mount and bumper mount plate, secur-
ing with hair pin.
IMPORTANT:
installing clamshell unit.
SECURE
WITH
HAIR PIN
STEP 15: Hook the large hole of each actuating
arm onto the hook on each side of the rear cover.
Then secure the other end of the arm onto the
inside of each side of the handle weldment with
HOOK
one 3/8-16 x 2" hex bolt and nyloc nut. Tighten
LARGE
snugly. NOTE: Make sure bend of arm is up.
HOLE OF
ARM
HERE
Push handle down to lock cover.
8
Assistance is required when
Assistance is required when