Snapper 7600036 Owner's Manual

SNAPPER & SIMPLICITY RZT/JAVELIN RIDING MOWERS
!
DO NOT attempt any adjustments, maintenance, repairs, or service with engine running. Stop engine. Engage
parking brake. Remove key. Remove spark plug wire and secure wire away from spark plug. Engine, muffler and
surrounding areas are extremely hot. Avoid serious burns; allow components to cool down before installing kit.
Replace worn or damaged parts prior to operating. Use approved fuel container. DO NOT smoke near open fuel
container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes
before refilling. Make sure that fuel cap is tightened securely. Wipe off any spilled fuel before starting engine.
STEP 1:
a. Raise and block the rear of the machine to gain access to
the transmissions on the underside of the machine.
b. With the machine securely blocked, move the motion
control levers in from their neutral lock positions, in order to
disengage the parking brake.
!
WARNING
Failure to securely block the machine may result in
severe personal injury or equipment damage.
STEP 2:
a. Remove the cotter pin securing the brake rod and brake
return spring to the right brake arm. Remove the rod end
and spring from the brake arm pin. See Figure 1.
IMPORTANT: The brake spring contains stored energy, and
should be removed from the brake arm carefully.
b. Remove the hex bolt and washer securing the right brake
arm to the transmission.
brake arm.
SPRING (RIGHT
SIDE ONLY)
BRAKE ARM
FIGURE 1
(Right transmission shown, viewed from
under rear of machine looking forward)
7600036 BRAKE KIT FOR
WARNING
See Figure 1. Remove the
BRAKE ROD
COTTER PIN
BOLT &
WASHER
STEP 3:
a. Install the supplied pin and bushing into the new brake
arm. See Figure 2. NOTE: The pin and/or bushing may
already be installed into the brake arm. If so, continue to
Step 3b.
!
PIN
BUSHING
(Right brake arm shown, left arm opposite)
b. Install the new brake arm onto the transmission, securing
with the supplied washer and hex bolt. Torque the bolt to
80-120 in-lbs.
c. Install the spring and brake rod onto the brake arm pin,
securing with the cotter pin removed in Step 2.
See Figure 1.
(Continued Other Side)
INSTRUCTION No. 7100881 (I.R. 7/25/2006)
1
FIGURE 2
TP 200-5215-00-AT-SN
!