Table of Contents
Advertisement
Operating Instructions
4.4 Calibration
4.4.1 Calibration Point 1 - Measuring Value
4.4.2 Calibration Point 1 - Raw Value
4.4.3 Calibration Point 2 - Measuring Value
4.4.4 Calibration Point 2 - Raw Value
4.4.5 Calibration Point N - Measuring Value
4.4.6 Calibration Point N - Raw Value
£
¤
With
and
select according to your
C
significance, with
leave the menu
without any change, with
entry and switch to a deeper menu level.
Measuring value in phys. units.
Range: Measuring start - Measuring end
C
With
set the value to 0.0 to start enter the
numbers of the measuring range, with
transfer the entry and leave the menu level.
Indicate the initial value to the value
displayed, if pressed
8
. With
menu without any change.
All other points are calibrated as the first one.
Measuring value in phys. units.
Range: Measuring start - Measuring end
Indicate the initial value to the value displayed.
Only necessary, if you are disturbed by
the non-linearity
(see diagram on the right side).
The measuring points of the nominal
characteristic curve will be typed in
and calibrated to the actual
characteristic curve. The customization
will be done by the evaluation unit.
The output values are linear.
Measuring value in phys. units.
Range:
Measuring start - Measuring end
Indicate the initial value to the value displayed.
4.4 Calibration
4.4.1 Val. P1
4.4.2 Calibration P1
transfer the
8
4.4.1 Val P2
4.4.2 Calibration P2
Calibration
Calibration Point 1
8
Calibration
Calibration Point 1
C
leave the
0.015663
Akt.: 0.015009
100
90
80
70
60
50
40
30
20
10
0
0
1
£
1.
0.00
¤
1.58
C
8
q
7
8
9
4
5
6
0.0 kg/h
1
2
3
0
C
8
C
8
Set Points
Stützpunktkennlinie
ist
soll
Diff 1
Diff 2
Diff 3
Diff 4
Diff 5
Diff 6
Diff 7
Diff 8
Diff 9
2
3
4
5
6
7
8
9
10
Measuring Points
Messpunkte
21
Advertisement
Table of Contents
Need help?
Do you have a question about the SolidFlow and is the answer not in the manual?
Questions and answers