Table of Contents
Advertisement
Chapter 4 - Configuration Management
4.4.4 VACM Group
VACM (View-based Access Control
Model) Group is used to configure
the information of SNMPV3 VACM
Group.
The VACM Group page has the
following configuration parameters:
• Group Name: Enter the security
group name.
Figure 32. VACM Group
• Read View Name: Enter the Read
View Name that the Group belongs to. The related SNMP messages are
Get, GetNext, GetBulk.
• Write View Name: Enter the Write View Name that the Group belongs to.
The related SNMP message is Set.
• Notify View Name: Enter the Notify View Name that the Group belongs
to. The related SNMP messages are Trap, Report.
• Security Model: Enter the Security Model Name that the Group belongs
to. Any is suitable for v1,v2,v3. USM is SNMPv3 related.
• Security level: Enter the Security level Name that the Group belongs to.
Only NoAuth, AuthNopriv, AuthPriv can be chosen.
Click <Add> to create a new VACM group. To remove an existing VACM
Group, select the group and click <Remove>. To update an existing entry,
select the group and click <Modify>. Click <OK> to save the changes on
this page. Click <Reload> to refresh the settings. To permanently save the
new configuration, go to the Save Configuration page, then click <Save>.
4.4.5 VACM View
VA C M ( V i e w - b a s e d A c c e s s
Control Model) View is used to view
the information of SNMPV3 VACM
Group.
The VACM View has the following
parameters:
• View Name: Enter the security
group name.
Figure 33. VACM View
• Vi e w Ty p e : S e l e c t t h e Vi e w
Type that the View belongs to. Included or Excluded when View Subtree
ASUS GigaX 1024i+
31
Advertisement
Table of Contents
