Table of Contents
Advertisement
GigaX Series L2 Managed Switch User's Guide
4.6.3
Trap Setting
By setting trap destination IP addresses and community names, you can
enable SNMP trap function to send trap packets in different versions(v1 or v2c).
Click
refresh the page.
4.6.4
VACM Group
VACM(View-based Access Control Model) Group is used to configure the
information of SNMPV3 VACM
Group Name: enter the security group name.
Read View Name: enter the Read View Name that the Group belongs.
The related SNMP messages are Get,GetNext,GetBulk.
Write View Name: enter the Write View Name that the Group belongs.
The related SNMP message is Set.
Notify View Name: enter the Notify View Name that the Group belongs.
The related SNMP messages are Trap,Report..
52
to save the configuration permanently or
Figure 30. Trap Setting
Group.
to
Advertisement
Table of Contents
