Table of Contents
Advertisement
B.6 Security Setup
The
setup provides both a Supervisor and a User password. If you use
ezPORT
both passwords, the Supervisor password must be set first.
The system can be configured so that all users must enter a password every time
the system boots or when
password or User password.
Main
Advanced
Security Settings
Supervisor Password
User Password
Change Supervisor Password
Change User Password
Clear User Password
Boot Sector Virus Protection
To reset the security in the case of a forgotten password you must clear the
NVRAM and reconfigure.
To clear the CMOS password:
• Turn off power to the unit.
• Momentarily short pins of E3 for approximately five seconds.
• Power up the unit.
When power is reapplied to the unit, the CMOS password will be cleared.
setup is executed, using either the Supervisor
ezPORT
BIOS SETUP UTILITY
PCIPnP
Boot
:
Not Installed
:
Not Installed
[Disabled]
002.53 (C) Copyright 1985-2002, American Megatrends, Inc.
Security
Chipset
Exit
Install or Change the
password.
←→
Select Screen
↑↓
Select Item
Enter Change
F1
General Help
F10
Save and Exit
ESC
Exit
Appendix B: AMI BIOS Setup Utility 67
Advertisement
Table of Contents
