Introduction; Installation - Marmitek SW12 User Manual

INSTALLATION INSTRUCTIONS FOR MARMITEK X-10 IN
WALL SHUTTER MODULE SW12

INTRODUCTION

This unit allows a motorized blind to be controlled either manually
from a momentary switch with two normally open contacts
connected to the unit, or remotely by serial Marmitek X-10 Powerline
messages sent from a suitable controller. When controlled serially the
blind can be made to go to intermediate settings in addition to fully
up or fully down.
Window parameters, such as Window Size and Current Position, together with the unit's
address are set into it by the user when the unit is put into Install Mode and these are stored in
permanent memory. This data is retained even through a loss of power.

1. INSTALLATION

Switch off appropriate mains fuse and
master switch!
Important : 230V - 50Hz - 3A per channel
max.
To install the SW12, neutral and phase are
required at the installation point.
• Take the wall switch out of the wall box.
• Disconnect all wires from the switch.
• Connect the live to the terminal wire L (3, Live) of the SW12
and to the switch as described in the drawing.
• Connect the neutral to the N (2, Neutral) terminal wire of the
SW12 and to the Neutral of the Motor.
• Connect the DN (1) terminal of SW12 to Motor Down, the UP
(4) terminal to Motor Up.
• Connect the Blue (5) wire coming from the SW12 to the Up key
of the switch, the Orange (6) wire from the SW12 to the Down
key of the switch.
• Put the SW12 into the wall box and re-fix the wall switch on the wall box.
• Switch on mains fuse and master switch.

M
Up Down
5 6
1 2 3 4
© MARMITEK