Instructions For Use Ss12™ Wireless Switch; Introduction; Properties; Change Of The Housecode - Marmitek X10 SS12E User Manual

INSTRUCTIONS FOR USE SS12™ WIRELESS SWITCH

INTRODUCTION

Congratulations buying the Marmitek X10 SS12 wireless
switch. This is a super thin, elegant wireless switch. It is the
ideal solution for situations where an extra switch is
needed without installing wires. It is to install on walls,
glass, doors tables etc. and transmits high frequent signals
through walls and ceilings. The SS12 wireless switch
transmits radio graphical signals to an X10 Transceiver
TM13, IRRF7243 or Marmitek X10 Alarm station. Then the
Transceiver or Station transmits these signals via the in
your house already installed electric wiring. Through this
you can switch on and off your lighting (or apparatus)
connected to X10 receivers (lighting can be dimmed also).
The SS12 is completely wireless and battery powered.

PROPERTIES

The switches are delivered standard at HouseCode A.

CHANGE OF THE HOUSECODE

1. Press the left button ON and keep it pressed. The red
LED flashes shortly. After 15 seconds the present set-
up is shown: 1 flash is HouseCode A, 2 flashes is
HouseCode B etc.
2. Release the button ON.
3. Now press shortly for the desired HouseCode on the
same ON button (1x = A, 2x = B etc). The LED flashes
every time you press the button.
4. At the last time keep the button pressed. After 3
seconds the LED shows the set-up HouseCode. Now
release the button.
SS12
7