Technical Data; Safety Rules - Hilti DX462 Operating Instructions Manual

4. Technical data

DX 462 tool
Weight
Tool length
Nail length
Recommended maximum fastening rate
en
Cartridges
Power regulation

5. Safety rules

5.1 Basic safety instructions
In addition to the safety rules listed in the individual sec-
tions of these operating instructions, the following points
must be strictly observed at all times.
5.2 Use as intended
The tool is designed for professional use in fastening
applications in construction where nails, threaded studs
and composite fasteners are driven into concrete, steel
and sand-lime block masonry.
5.3 Improper use
G Manipulation or modification of the tool is not per-
missible.
G Do not operate the tool in an explosive or flammable
atmosphere, unless the tool is approved for such use.
G To avoid the risk of injury, use only original Hilti fas-
teners, cartridges, accessories and spare parts or those
of equivalent quality.
G Observe the information printed in the operating
instructions concerning operation, care and mainte-
nance.
G Never point the tool at yourself or any bystander.
G Never press the muzzle of the tool against your hand
or other part of your body.
G Do not drive nails into materials such as glass, marble,
plastic, bronze, brass, copper, natural rock, insulation
material, hollow brick, glazed tile, thin-gauge sheet metal
(< 4 mm), grey cast iron, spheroidal cast iron and gas
concrete.
5.4 Technology
G This tool is designed with the latest available tech-
nology.
G The tool and its ancillary equipment may present haz-
ards when used incorrectly by untrained personnel or
not as directed.
18
3.1 kg
405 mm
Max. 47 mm
700 per hour
6.8/11 M (27 cal. short) green, yellow, red, black
4 cartridge power levels, regulation wheel with locking
function
5.5 Make the workplace safe
G Objects which could cause injury should be removed
from the working area.
G Operate the tool only in well-ventilated working areas.
G The tool is for hand-held use only.
G Avoid unfavorable body positions. Work from a secure
stance and stay in balance at all times
G Keep other persons, children in particular, outside the
working area.
G Before using the tool, make sure that no one
is standing behind or below the point where fasteners
are to be driven.
G Keep the grip dry, clean and free from oil and grease.
5.6 General safety precautions
G Operate the tool only as directed and only when it is
in faultless condition.
G Use the splinter guard when the application permits.
G If a cartridge misfires or fails to ignite, proceed as fol-
lows:
1. Keep the tool pressed against the working surface for
30 seconds.
2. If the cartridge still fails to fire, withdraw the tool from
the working surface, taking care that it is not pointed
towards your body or bystanders.
3. Manually advance the cartridge strip one cartridge.
Use up the remaining cartridges on the strip. Remove
the used cartridge strip and dispose of it in such a
way that it can be neither reused nor misused.
G If 2–3 cartridge misfires occur in succession (with-
out clearly audible noise of the cartridge firing and the
fastener being driven with significantly less power), pro-
ceed as follows:
1. Stop using the tool immediately.
2. Disassemble the tool (see 8.3).
3. Check that the correct combination of fastener guide,
piston and fastener are used (see 6.2).