FiField Bonfire Owner's Manual page 17

Note: When looking at the metal extension the fender has a short end
and a long end. The long end goes to the back of the wheel to protect
your legs from water, dirt, etc.
10. To finish fender installation the
extensions holding the fender
to the fork must also be
tightened. To do this, locate
the bolts shown to the right
and the free extensions on the
fender. Attach the extensions
as shown below and tighten
with a 4mm Allen wrench to
hold the fender in place.
11. Locate the pedals. Each pedal will be marked with a distinctive "L"
and "R" which represents the left and right pedal respectively.
Place the left pedal on the left side of the bike and tighten the
pedal in place. Repeat this process for the right pedal. To ensure
the pedals will not slip, use your 15mm wrench to continue to
tighten.
12. Congratulations! Your bike is completely assembled and ready to
ride. However, before you ride we also recommend making a
couple adjustments to your bike to make sure the ride is perfect.
We do not recommend you make these adjustments yourself.
13