FiField Bonfire Owner's Manual page 16

8. Locate the wire coming from the motor shown below (located
near the front wheel) and the wire attached to the fork. Align the
two arrows shown below and push the connection together until
a click is heard. Failure to align the arrows properly will damage
the bike. The horizontal black line should be covered completely
by the other wire to ensure a full connection is made. To check,
turn on the battery. If error code 24 is displayed in the bottom
right corner then the connection is not complete. If the error
code 24 appears briefly then disappears the connection is
complete. On the side there is a small Phillips head screw; use this
to attach the cable to the fork and secure it in place.
9. Locate the front fender. There is a small metal piece extending
from the top of the fender; this extension is the center and will
be used to hold the fender and front light in place. To attach both
the light and the fender, put
the light back in its original
position and insert the
fender from the back until
the metal clip is over the
light extension. The image
shows the proper order for
installation (note: this
picture was taken from the
front of the wheel). When
complete use a 4mm allen
wrench and tighten.
12