Advertisement
IMPORTANT!
Please read and follow the directions below before and during the installation process. Check all
state, federal and local laws before installing the iPad dash kit. It is the responsibility of the user to determine, and
obey, all applicable laws regarding use of electronic devices while operating a vehicle.
INSTALLATION GUIDE
INSTALLATION STEPS
1.
Use the supplied alcohol prep pad to clean the surface area
around the Factory radio panel where the iPad kit will make
contact with the surface. (Place the kit over the factory
stereo to verify proper fitments if needed. iPad kits are
designed to exactly match the shape and contour of the
Factory stereo panel) FIG 1
2.
Peel the adhesive backing from the 3M™ strips on the back
of the kit. FIG 2
3.
Carefully align the iPad kit over the factory stereo location
and press firmly for a full 60 seconds (adhesive fully cures
after 24hrs).
INSTALLATION GUIDE
MOUNTING / REMOVING THE TABLET
1.
Carefully slide the iPad, with side controls UP, in (or out) of the channel as shown in FIG 3.
2.
Sample illustration of end result FIG 4.
FIGURE 3
FIGURE 4
2
Kit Preparation & Installation
Mounting/Removing
FIGURE 1
FIGURE 2
Advertisement
