Advertisement
STEP 8: Install the U-tube onto the top of the bagger chan-
nel, securing with three 5/16-24 x 1-5/8" curved head bolts,
split lock washers, and hex nuts. See Figure 13. Tighten
hardware securely.
U-TUBE
WASHER &
NUT (3)
BACK OF BAGGER
CHANNEL
FIGURE 13
STEP 9: Install the center tube into the center of the bagger
channel, securing with two 5/16-24 x 1-5/8" curved head
bolts, split lock washers, and hex nuts. Tighten hardware
securely. Also insert one tube end cap into each of the three
open tube ends. See Figure 14.
WASHER &
NUT (2)
FIGURE 14
STEP 10: Install the cover hinge to the inside back of the
cover assembly, securing with four 1/4 x 3/4" carriage bolts,
flat washers, and lock nuts. Also, install the cover handle
onto the screen support bar, behind the front of the cover
assembly, securing with two pan head screws and lock nuts.
See Figure 15.
NOTE: On some units, the cover handle has been pre-
assembled onto the cover assembly.
CURVED HEAD
BOLT (3)
CENTER
TUBE
TUBE END
CAP (3)
CURVED HEAD
BOLT (2)
LOCK NUT (2)
COVER
HANDLE
STEP 11: Attach the cover assembly to the bagger channel
by aligning the holes in the cover hinge with the top set of
holes in the bagger channel. Insert the hinge pin through
the holes, and secure with a hair pin. See Figure 16.
COVER
ASSEMBLY
HINGE PIN
4
PAN HEAD
SCREW (2)
CARRIAGE
WASHER (4)
LOCK NUT (4)
FIGURE 15
FIGURE 16
BOLT (4)
COVER
HINGE
FLAT
HAIR PIN
BAGGER
CHANNEL
Advertisement
