Snapper 7600023, 7600024 Owner's Manual page 3

STEP 5: Install the bag adapter (42" Deck):
a. Remove the wing nuts, split lock washers, flat washers,
and hex nuts that secure the deflector to the deck, and
remove the deflector. See Figure 8.
REMOVE
NUTS AND
WASHERS
b. Fit the two top holes in the adapter over the wing nut
studs. Secure the adapter with the flat washers, split lock
washers and wing nuts removed in Step 5a.
securely. See Figure 9.
STEP 6: Install the grass catcher support:
a. Remove the three noted bolts and nuts from the right rear
of the unit. See Figure 10.
FIGURE 10
REMOVE
DEFLECTOR
FIGURE 8
ADAPTER
FIGURE 9
HARDWARE
b. Install the catcher support onto the unit, securing with the
hardware noted in Figure 11. Tighten all hardware securely.
NOTE: Be sure to reinstall any components that may have
been removed when removing the hardware in Step 6a.
SECURE WITH
SUPPLIED 5/16
x 3/4" HEX
WASHER HEAD
BOLT & FLANGE
LOCK NUT
STEP 7: Insert the bagger channel into the grass catcher
Tighten support, and secure with two 1/2 x 4-3/16" clevis pins,
washers, and hair pins. See Figure 12.
INSERT CHANNEL
INTO CATCHER
INSTALL
SUPPORT
WASHERS
AND WING
NUTS
CLEVIS PIN (2)
INSTALL
REMOVE
3
SECURE WITH
SUPPLIED 5/16
x 3/4" HEX
HEAD BOLT
SECURE WITH
REMOVED
HARDWARE
FIGURE 11
WASHER &
HAIR PIN (2)
FROM UNIT)
FIGURE 12
WASHER
CATCHER
SUPPORT
(SHOWN
DETACHED