Deck Leveling Adjustment - Snapper 5900700 Operator's Manual

Deck Leveling Adjustment

To Level the Mower Deck:
1. Park the machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. Pull the cutting height adjustment handle (A, Figure 32)
up and out of the handle lock position (B) and crank the
handle CLOCKWISE and adjust the deck to the 3" (7,6
cm) position.
3. Repeat process for other side of machine.
NOTE: Both sides of the deck must be adjusted to the same
height.
4. Place 2 x 4 blocks under the rear of the mower deck
with the 3-1/2" sides being vertical. See Figure 33.
5. Loosen the deck leveling hardware (D, Figure 32) on
both sides of the machine.
6. Make sure that the rear of the deck is resting on the 2 x
4's. Tighten the deck leveling hardware on both sides of
the machine.
7. Remove all 2 x 4 blocks from under the mower deck.
A
Figure 33. 2 x 4 Locations
A. 36" Mower Deck
B. 48" Mower Deck
C. 2 x 4 Blocks
D. Arrow Indicating the Front of the Machine
C
D
Regular Maintenance
B
Figure 32. Remove the Cutter Deck Guard
A. Cutter Height Adjustment Handle
B. Handle Lock Position
C. Cutting Height Indicator
D. Deck Leveling Hardware
B
D
A
D
C
C
31