RegWr MaJflteflaflce
Deck Leveling Adjustment
ToLeveltheMowerDeck:
1. Park the machine on a flat. level surface. Disengagethe
PTO,stop the engine and engage the parking brake.
Reartires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. Pull the cutting height adjustment handle (A, Figure 32)
up and out of the handle lock position (B) and crank the
handle CLOCKWISE and adjust the deck to the 3" (7,6
cm) position.
3. Repeat process for other side of machine.
NOTE: Both sides of the deck must be adjusted to the same
heighL
4. Place2 x 4 blocks under the rear of the mower deck
with the 3-1/2" sides being vertical. See Figure 33.
5. Loosen the deck leveling hardware (D, Figure 32) on
both sides of the machine.
6. Make sure that the rear of the deck is resting on the 2 x
4's. Tighten the deck leveling hardware on both sides of
the machine.
7. Removeall 2 x 4 blocks from under the mower deck.
Figure 3!
Remove the Cutter Deck Guard
A. Cutter Height Adjusflnent Handle
B, Handle Lock Position
C. Cutting Height Indicator
D. Deck Leveling Hardware
®
®
Figure 33. 2 x4 Locations
A. 36"Mower Deck
B, 48" Mower Deck
C. 2 x 4 Blocks
D. Arrow Indicating the Front of the Machine
31