PEERLESS Smartmount D-FPT-220 Installation And Assembly Manual page 8

For Flat Back Display
Begin with the shortest length screw, hand thread through washer and tilt bracket into display as shown below.
2-1
Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over tighten. If
screw cannot make three full turns into the display, select a longer length screw from the baffl ed fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through washer, tilt bracket and spacer in that order into display as
2-2
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
DISPLAY
SPACER
8 of 38
fi g. 2.1
WASHER
SCREW
TILT BRACKET
(BB or CC)
fi g. 2.2
WASHER
SCREW
TILT BRACKET
(BB or CC)
ISSUED: 11-26-07 SHEET #: 202-9256-6 04-05-11