PHILIPS Respironics ComfortGel Blue Fittings Manual page 4

Removing the mask
To remove the mask, disconnect one or both
ball-and-socket Quick Clip(s). Grab the bottom
of the headgear on the back of the head and
pull the mask gently up and over the head.
Use the Quick Clip to remove the mask and
maintain mask and headgear adjustments
from day-to-day.
Fitting tip
If the headgear is too long from the top of
the head to the top of the neck, roll the
bottom headgear strap over or under to
create a better fit. The Quick Clip will
rotate to accommodate the new length.
Attaching the ComfortFusion and ComfortSelect cushion
All three pieces—faceplate, cushion, and
retaining ring—have black alignment marks
to make aligning and attaching the
cushion simple.
1. Place the cushion on the outside
of the faceplate, aligning the black
alignment marks and fitting the
cutouts on the cushion over the
notches on the faceplate.
4. Gently tug on the cushion and
the ring to make sure all of the
parts are securely in place.
Retaining
ring
Cushion
Faceplate
2. Position the retaining ring on
the cushion with the tabs facing
downward using the black
alignment marks.
Tabs
Alignment
marks
3. Slide the retaining ring with tabs
facing downward around the
cushion and press firmly until all
three sides click into place.