Advertisement
GETTING TO KNOW YOUR TOOL
1. Carrying case
2. 3/8" keyless chuck
3. Torque setting ring
4. 2 speed gearbox selector
5. Forward/reverse switch
6. 12V Lithium-ion cordless drill
7. 12V Lithium-ion battery
8. Variable speed trigger
SPECIFICATIONS
Model ........................................................................................................................8010L
Voltage..........................................................................................................................12V
Battery type ............................................................................................1300m/Ah (li-ion)
Keyless chuck ..............................................................................................................3/8"
Number of speeds and range ........................................................2 (0-300, 0-1050 RPM)
Torque settings ........................................................................................................17 + 1
Torque..................................................................................................................133 in/lbs
Charger ....................................................................................................................1 hour
Figure 1
9. LED work light
10. 12V Lithium-ion battery charger
11. 6 screwdriver bits (Robertson #1,
Robertson #2, Phillips #1, Phillips #2,
5mm flat, 6mm flat)
12. Magnetic bit extension
13. 6 drill bits (1.5, 2.5, 3, 4, 5, 6mm)
OPERATION
Using your 12V Li-ion cordless drill
WARNING: Do not install battery until the accessory is
installed securely to the tool. Wear protective gloves
and safety glasses, an accessory can become extremely
hot during operation, danger of burns!
Charging the battery
To charge the battery (A) Fig.2, plug charger (B) power
cord into a 120V AC receptacle (do not use extension
cord). The red LED (C) will light up to indicate power to
the charger. Place the battery stem into the charger
opening, make sure it is fully inserted into charger, the
green LED (D) will start flashing indicating the charging
procedure has begun. Once the green LED (D) stops
flashing, the battery is fully charged and ready to use.
Installing/removing battery from drill
To install a battery (A) Fig.3 into the base of the cordless
drill, simply slide the battery up into the base of the drill
and push it all the way until the battery clips (B) snap and
hold the battery into place.
To remove the battery from the base of the drill,
simultaneously press both battery clips on both sides of
the battery and pull the battery away from the drill.
Variable speed trigger
Your cordless drill is equipped with a variable speed
trigger (A) Fig.4. The speed can be controled from the
minimum to the maximum RPM just by the pressure
applied to the trigger switch. Apply more pressure to
increase speed and apply less pressure to decrease
speed. Release trigger to stop drill.
Forward/reverse switch and trigger lock
Your cordless drill is equipped with a forward/reverse
switch and trigger lock (B) Fig.4. It is located above the
trigger. This switch is designed to change the direction of
rotation of the keyless chuck and to lock the trigger to
help prevent accidental starts and battery discharge. For
a forward rotation (with the chuck pointing away from
you) move the lever to the left. For reverse rotation move
the lever to the right. To lock the trigger, place the lever in the center position.
WARNING! Do not change the rotation direction until the drill chuck has come to a
complete stop. Changing the rotation during an operation can cause damage to the
tool.
Figure 2
Figure 3
Figure 4
Advertisement
