Related Manuals for King Canada 8310ADN
Summary of Contents for King Canada 8310ADN
- Page 1 3/8” VARIABLE SPEED RIGHT ANGLE DRILL MODEL: 8310ADN INSTRUCTION MANUAL COPYRIGHT © 2012 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
Please keep your dated proof of purchase for warranty and servicing purposes. LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials. - Page 3 GENERAL & SPECIFIC SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL Read and understand the instruction manual and labels affixed to the tool. Learn its application and limitations as well as its specific potential hazards. 2. Don’t use power tools in damp or wet locations or expose them to rain. Keep work area well lit and provide adequate surrounding work space.
-
Page 4: Electrical Information
ELECTRICAL INFORMATION WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. -
Page 5: Getting To Know Your Tool
6. Carbon brush cap (1 of 2) 3. Variable speed trigger 7. Power cord (polarized plug) 4. Trigger lock-on button 8. Power-on indicator LED SPECIFICATIONS Model ........................8310ADN Chuck size....................3/8” (Ø10mm) Amperage ........................3.5A No load speed (RPM)................0-1,600 (variable) Voltage ........................120V Cycle/Phase ....................60Hz, 1 phase... -
Page 6: Operation
OPERATION FIXING & CHANGING DRILL BIT 1) Turn the Right Angle Drill off first. 2) Clean the shivers and any other foreign objects away from the bit (A) Fig.1 and chuck (B), otherwise the bit might not be tightened securely and thus will induce severe personal injuries. - Page 7 OPERATION Operational Guidelines The working materials should be within: “wood, metal, plastic, resin board, concrete”. • When drilling hard, smooth surfaces, use a center punch to mark the desired hole location. This will prevent the drill from slipping off center as the hole is started. •...
-
Page 8: Maintenance
(both carbon brushes should be replaced at the same time). Install new carbon brushes and reinstall the carbon brush caps. If you are unsure about these instructions, we recommend that you get a qualified service technician to replace the carbon brushes. Contact a King Canada service centre.