Advertisement
GETTING TO KNOW YOUR TOOL
1. Carrying case
2. 1/4" hex. drive quick release chuck
3. LED work light
4. Variable speed trigger
5. Forward/reverse switch
6. 12V Lithium-ion cordless impact driver
SPECIFICATIONS
Model ........................................................................................................................8012L
Voltage..........................................................................................................................12V
Battery type ............................................................................................1300m/Ah (li-ion)
Quick release chuck ..........................................................................................1/4" (hex.)
Speed range ..................................................................................................0-2000 RPM
Impacts per minute ..................................................................................................0-3000
Torque..................................................................................................................710 in/lbs
Charger ....................................................................................................................1 hour
Figure 1
7. 12V Lithium-ion battery
8. 4 nut drivers with 1/4" hex. shank
9. 1/4" socket adaptor
10. 2 screwdriver bits (Robertson #1, #2)
11. 12V Lithium-ion battery charger
OPERATION
Using your 12V Li-ion cordless impact driver
WARNING: Do not install battery until the accessory is
installed securely to the tool.
Charging the battery
To charge the battery (A) Fig.2, plug charger (B) power
cord into a 120V AC receptacle (do not use extension
cord). The red LED (C) will light up to indicate power to
the charger. Place the battery stem into the charger
opening, make sure it is fully inserted into charger, the
green LED (D) will start flashing indicating the charging
procedure has begun. Once the green LED (D) stops
flashing, the battery is fully charged and ready to use.
Installing/removing battery from impact driver
To install a battery (A) Fig.3 into the base of the cordless
impact driver, simply slide the battery up into the base
and push it all the way until the battery clips (B) snap and
hold the battery into place.
To remove the battery from the base, simultaneously
press both battery clips on both sides of the battery and
pull the battery away from the impact driver.
Variable speed trigger
Your cordless impact driver is equipped with a variable
speed trigger (A) Fig.4. The speed can be controled from
the minimum to the maximum RPM just by the pressure
applied to the trigger switch. Apply more pressure to
increase speed and apply less pressure to decrease
speed. Release trigger to stop drill.
Forward/reverse switch and trigger lock
Your cordless impact driver is equipped with a
forward/reverse switch and trigger lock (B) Fig.4. It is
located above the trigger. This switch is designed to
change the direction of rotation of the quick change
chuck and to lock the trigger to help prevent accidental
starts and battery discharge. For a forward rotation (with
the chuck pointing away from you) move the lever to the
left. For reverse rotation move the lever to the right. To
lock the trigger, place the lever in the centre position.
WARNING! Do not change the rotation direction until
the impact driver chuck has come to a complete stop.
Changing the rotation during an operation can cause
Electric brake
This impact driver is equipped with an electric brake. If the tool consistantly fails to stop
quickly after the trigger is released, have the tool serviced.
LED light
Your cordless impact driver features a LED light system (C) Fig.4 which gets activated by
pressing the trigger. This feature is ideal when working in partially lit work environments.
Figure 2
Figure 3
Figure 4
damage to the tool.
Advertisement
