Table of Contents
Advertisement
4.3 Surveillance – Record - General
Reminder:
Save each tab individually before proceeding to next tab
This section covers the general system wide setting of the XDR
1.
System – PAL / NTSC (Default = NTSC)
2.
Overwrite: How the system stores new recording once the storage is full
- Capacity: As SD storage is full, system will overwrite oldest data
- Date: XDR will overwrite old data based on date
- Alarm: XDR will overwrite old data based on alarm
4.
Lock Duration: Number of days to lock an alarm event file 1 – 31 days (Default 7 days)
5.
Pre-Recording: Enable/ Disable and Length of recording before an event
(Recommend 1 to 3 minutes)
4.4 Surveillance – Record – Main Stream
This section enables, disables individual cameras as well as custom parameters for each. If setting
is same for all cameras, click "Copy To > All".
1.
Channel: Select the camera from Channel 1 - 12
2.
Channel Name: Assign name to each channel - optional ( rear, side door, interior...etc)
3.
Enable: Enable or Disable each camera in the system. If camera is NOT enabled, it will NOT
record in the system
4.
Resolution: Select resolution for camera
Analog HD (AHD) Camera = CH 1 ~ 8 = 1080P AHD, 720P AHD, D1
IPC HD Camera = CH 9 – 12 = 1080P HD, 720P HD Resolution
5.
Frame Rate: Select frame rate of individual camera (1 – 30FPS) Default 25
Higher the frame rate, bigger the file storage size
Surveillance – Record – General / Main Stream
20
Advertisement
Table of Contents
