Table of Contents
Advertisement
Network Features
Using Network Features
Connection to the network allows you to perform
the following:
Checking the current status of the projector.
Remotely controlling the projector.
Receiving the e-mail report for the projector.
Making the network settings for the projector.
Monitoring networks and supporting control
protocol (Advertisement, ADCP, PJ Talk, PJ Link,
SNMP, AMX DDDP [Dynamic Device Discovery
Protocol], Crestron RoomView).
Using the HTML Viewer Function.
Setting the time for the HTML viewer.
Restoring the network settings to their factory
defaults.
Using the Software Update Function.
Notes
When connecting this projector with the network,
consult with the network administrator. The network
must be secured.
When using this projector connected with the network,
access the control window via a Web browser and
change the access limitation of the factory preset values
(page 36). It is recommended to change the password
regularly.
When the setting on the Web browser is completed,
close the Web browser to log out.
Supported Web browsers are Internet Explorer (version 11
or later) and Safari (version 11 or later).
The menu displays only English.
If the browser of your computer is set to [Use a proxy
server] when you have access to the projector from your
computer, click the check mark to set accessing without
using a proxy server.
SNMP, AMX DDDP, and Crestron RoomView do not
support IPv6.
The following menu displays used for the explanation
may be different depending on the model you are using.
Displaying the Control Window of the
Projector with a Web Browser
1
Connect the LAN cable (page 11).
2
Set the network settings for the projector
using "Network Setting" in the Connection/
Power menu (page 30).
3
Start a Web browser on the computer, enter
the following in the address field, then press
the Enter key on your computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the projector)
When connecting with the IPv6 address
http://[xxxx:xxxx:••• xxxx]
You can confirm the IP address of the
projector under "Network Setting" in the
Connection/Power menu (page 30).
The following window appears in the Web
browser.
Once you make the network settings, you can
open the control window only by performing step
3 of this procedure.
Operating the control window
Switching the page
Click one of the Page Switching buttons to display
the desired setting page.
Setting the access limitation
You can limit a user for accessing any particular
page.
Administrator: Allowed access to all pages
User: Allowed access to all pages except the
Setup page
36
Page Switching buttons
Hide quick links:
Advertisement
Table of Contents
