Advertisement
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for ROOTS Wizzard Series
Summary of Contents for ROOTS Wizzard Series
- Page 1 Wizzard Series Mini Floor Scrubber Instruction Manual...
-
Page 3: Table Of Contents
Please be advised explicitly that we cannot accept any legal claims out of the contents of this manual. If repair work has to be performed, make sure that only genuine spare parts are used since genuine spare parts only may guarantee continuous and dependable operation of your machine. Roots Multiclean Ltd. RKG Industrial Estate, Coimbatore - 641 006, India. -
Page 4: Know Your Machine
KNOW YOUR MACHINE For 24,34 & 44 machines. Pump Natural Tank Wizzard... -
Page 5: Technical Specification
TECHNICAL SPECIFICATION Technical data Units Scrubbing width Theoretical area coverage Power Supply V / Hz 230/50 230/50 230/50 230/50 230/50 230/50 230/50 Total Power 1000 Brush Speed Fresh water tank 1.2+3 1.7+4 Dirty water tank 378 X 340 X 378 X 340 X 378 X 340 X 378 X 440 X 378 X 440 X... - Page 6 TECHNICAL SPECIFICATION The machine also available in different power supply. Such as 220 & 110 Volts. Model Power Supply Total Power Brush Speed 24N/24T 220/60 1050 34N/34T 220/60 1050 220/60 1050 110/50 110/60 220/60 1200 110/50 110/60 Wizzard...
-
Page 7: Introduction
INTRODUCTION Preface This machine may be used, serviced and repaired only by persons who are familiar with the machine and are aware of possible hazards involved. The appropriate Accident Dear Customer, Prevention Regulations as well as applicable general regulations about safety and health at work must be complied Thank you for choosing to become the proud owner of with. -
Page 8: General Safety Instruction
GENERAL SAFETY INSTRUCTION Safety & Warning Symbols General Guidelines This machine is for WET scrubbing only. Ÿ All paragraphs in this manual referring to you personal safety, Apart from information contained in this manual, Ÿ the safety of your machine and the environment protection are generally applicable legal provisions for safety and attributed one of the following warning symbols. - Page 9 GENERAL SAFETY INSTRUCTION Abiding by the above general instructions can help - Do not clean the machine by means of vapour jet or Ÿ avoid having to read this book while trying to run the high pressure cleaning equipment. machine. - Do not USE the machine on steps.
- Page 10 GENERAL SAFETY INSTRUCTION This machine should always be connected to a fully earth Ÿ Do not clean the machine by means of power supply of the right voltage and frequency. vapour jet or high pressure cleaning When working on the electrical system, always disconnect Ÿ...
-
Page 11: First Operation
FIRST OPERATION It is an ideal machine to clean hard floors in small and medium 1. Bottom handle 7. Allen key areas like offices, hospitals, restaurants, shopping complexes 2. Machine body 8. Screws & washers and in many commercial applications. It dispenses / sprays 3. - Page 12 FIRST OPERATION Identification of Main Parts Note: 24 / 34 / 44 refers to the machine width in cm. Refer the (14) (10) given table for your model. (12) Model Figure Fig. d N - Natural model a,d,e,f Fig. e T - Tank model b,d,f P - Pump model...
- Page 13 FIRST OPERATION Optional accessories 2. Side Brush To wash the edges, the side brush shall be used. Switch off 1. Transporter and unplug the machine before fitting the side brush. The simply fitted trolley provides for ease of movement when Warning! Do not use side brush in a room with no wall transporting the machine.
- Page 14 FIRST OPERATION Principle of Operation L E F T R I G H T B O T T O M B O T T O M R E A R R E A R Front Cleaning liquid in the solution tank is applied to the floor by Slide the electric cable retainer into the top portion of RH Ÿ...
- Page 15 FIRST OPERATION Transport/Working Mode Control Rotate the knob to hold the auxillary tank. Ÿ The brushes are only loosely packed in the machine for Ÿ Slide this knob to TOP position (Working Ÿ transit, therefore the brush shafts must be fitted before Mode) to operate the machine.
-
Page 16: Machine Operation
MACHINE OPERATION MACHINE OPERATION Pull cable connect / disconnect control Insert the free end of pull cable into the Ÿ Before the washing operation starts valve body fitted in the fresh water tank. Press and twist clockwise to secure the Precleaning of floor is must before using the machine. - Page 17 MACHINE OPERATION Stop the liquid discharge approximately one foot before handle should not be kept pulled all the time. The duration Ÿ and frequency of pulling and releasing has to be adjusted the end of forward motion. continue to move forward up to suitable to match with the type of floor, extent of dirt.
-
Page 18: Maintenance
MAINTENANCE Electrical Diagram PUMP BR/W BR/W MOTOR MOTOR CAPACITOR CAPACITOR BL/BK BR/W 1. Electrical layout of N/T model 2. Electrical layout of P model Diagram 1(N/T) and diagram 2 (P) are made available in the cover (Power cord side) of the respective machine for service ADDITIONAL INFORMATION-WEEE purpose. - Page 19 MAINTENANCE Ÿ Remove the brushes by pushing the brush shaft out (Fig- Before undertaking the cleaning of machine, switch off ix). the machine and unplug from the electrical supply. Ÿ Wash the brushes either by dipping in a bucket/sink or in running water (Fig-x).
- Page 20 MAINTENANCE Brush selection guide Brush Type Type of floor First time Maintenance cleaning cleaning Ceramic, Mosaic, Wood, Standard Soft Profiled rubber, Vinyl, PVC. Short pile carpet Soft Soft All nature stone floors Soft Soft (Marble, Granite etc.) Customers may not interested to use same brushes in Smooth concrete Hard Standard...
- Page 21 MAINTENANCE Solution tank filter (N/T) Upkeep of your machine To get the maximum life of the machine ensure the following. The filter prevents clogging of the drip holes in the tank. Ÿ Periodically clean the filter to ensure uniform discharge of liquid.
- Page 22 MAINTENANCE Do’s & Don’t’s Don’t’s Do’s Do not leave the machine connected to the power supply Ÿ when not in use, always remove the plug from the mains The machine must be disconnected from the mains socket. Ÿ supply (by pulling the plug out) before changing the Do not use the machine where hazardous dust is present.
- Page 23 MAINTENANCE Trouble shooting Problem Remedy Problem Remedy Drum assembly Check the machine mode in Idle not rotating / Check the condion of teeth's in the side housing. Abnormal sound drum. Check the power supply. in the drum Machine not Check whether the circuit breaker getting switched is tripped.
-
Page 24: Notes
NOTES Wizzard... - Page 26 Phone: +91 (422) 4330 330 E-mail: rmclsales@rootsemail.com Roots Multiclean Ltd. Web: rootsmulticlean.in R.K.G. Industrial Estate, Ganapathy, Toll Free: 1800 41 99 77 9 Coimbatore - 641 006, India.
Need help?
Do you have a question about the Wizzard Series and is the answer not in the manual?
Questions and answers