High-Idle Mode - Ultraflex Power A Mark II Owner's Manual

ULTRAFLEX

2.4.3 HIGH-IDLE mode

The HIGH-IDLE mode allows the user to increase the engine idle speed.
To enable this mode the following conditions must be met:
- The station must be enabled.
- The DOCKING mode must not be enabled.
- There must be no failures that could prevent this mode from being enabled.
To disable the HIGH-IDLE mode, press the proper key on the user interface: the HIGH-IDLE red LED switches
off when this mode is disabled.
WARNING
In a twin-engine system the HIGH-IDLE mode can be enabled on one engine
only. In this case the HIGH-IDLE red LED will blink.
The HIGH-IDLE mode is disabled when changing the control station.
page 16
of 36-
POWER A MK2
To enable the HIGH-IDLE mode just press the proper
key on the user interface.
The proper red LED will light up indicating that the
HIGH-IDLE mode is on.
In the engine acceleration curve the high idle value
is set as the idle speed.
Owner's manual