Admonitions And Safety Symbols - Ericsson RBS 2308 User Manual

RBS 2308 and RBS 2309 User's Guide
3.1.2 Educational Requirements
The product safety instructions in the relevant manuals or documents require
that persons performing work on Ericsson products have the necessary
education, training and competence required to perform work correctly. For
certain work, additional or special training may be required, for example
authorization for Authorized Service Providers (ASP). ASP is an Ericsson
certification procedure.
A good understanding of technical English is required, or of the language
that the information is presented in, to ensure that these instructions can be
understood and complied with.
3.2

Admonitions and Safety Symbols

This section presents the types of admonitions and safety symbols used in all
documents for Ericsson system products. There are two types of system safety
admonitions that indicate risk to products: Do! and Stop!. When admonitions
are encountered anywhere in a document, the information included should be
read and any instructions should be followed.
The figures below show the symbols used to indicate product safety
admonitions:
Figure 13
Figure 14
The terms Do! and Stop! are defined below:
Do!
Stop!
The term "Note" is used to present important information that might otherwise
be overlooked.
3.2.1 Special Hazard Symbols
This section presents special hazard symbols used to indicate the risk of
Electrostatic Discharge (ESD):
28
Do Safety Symbol
Stop Safety Symbol
Indicates an action that must be performed to prevent
equipment damage, software corruption, data loss or
service interruption.
Indicates that action must be avoided to protect
equipment, software, data or service.
EN/LZT 720 0027 Uen R8A 2006-06-27