Advertisement
6
● Main Tire and Wheel Pants are installed on
the Tire shaft.
● Tire shaft
● M3 Nut
Main Gear
● Tire shaft are installed in the
Main gear.
● M4 Nut
● The right and the left are done by
the same process.
Be careful about the direction.
7
14
Forward
Forward
● Using an open ended
wrench, hold the axle
while the nut is installed.
● Install the tail wheel by M2 ×
20 Screw・M2 Nut
● A lock washer is used
under the nut.
● Use a drill to mark hole in the wheel pants side.
● Main gear is installed
in the fuselage.
M3 × 10 Hex head bolt
M3 Washer
M3 × 10 Hex head bolt
M3 Washer
● Fit the tail gear assembly into the bushing and
fit the tail gear retainer to the fuselage bottom
as shown. Drill two 1.6mm holes into the
fuselage using the retainer as a guide.
● Fill with CA glue
● Put on the M2 × 8
Tapping Screw
● M2.3 × 12
Tapping screw
Advertisement
