Disassembly For Repair; Removing The Case Assembly From The Chassis; Removing The Holder Assembly From The Chassis - Kenwood TK-2317 Service Manual

DISASSEMBLY FOR REPAIR / 维修拆卸
1. Removing the Case Assembly from the
Chassis
1. Remove the selector knob a and volume knob b .
2. Remove the two screws c .
3. Lift and remove the chassis from the case assembly d .
(Use a fl at-blade screwdriver to easily lift the chassis.)
2. Removing the Holder Assembly from
the Chassis
1. Remove the holder from the chassis.
Note: Taking care not to cut the speaker and microphone
lead.
2. Detach the solder of speaker and microphone lead from
the PCB beforehand.
3. Remove the packing e from the SP/MIC jack of the TX-
RX unit.
Note: To remove the Holder Assy from
the Chassis,use a flat-blade screwdriver
and insert to this hole.
注意 : 从机架取下扬声器座时，请将
一字螺丝刀插入箭头所示位置。
1. 从机体上拆卸机壳
1. 拆卸选择器旋钮 a 和音量旋钮 b 。
2. 拧下 2 个螺丝 c 。
3. 从机体拉出并卸下机壳 d 。
( 使用 一字 螺丝刀容易拉出机壳。)
c
c
d
2. 从机架卸下支架
1. 从机架卸下支架。
注意 : 小心不要折断扬声器引线和麦克风引线。
2. 卸下 PC 板上的扬声器引线和麦克风引线上的焊锡。
3. 卸下 SP/MIC 连接器的橡胶垫⑤。
蓝色
BLU /
黄色
YEL /
黑色
BLK /
红色
RED /
S-
M-
TK-2317
a
b
S+
M+
e
15