Motor And Feedback Connector - Aerotech ABL1000WB Series Hardware Manual

Electrical Specifications and Installation

3.1. Motor and Feedback Connector

Stages equipped with standard motors and encoders come from the factory completely wired and
assembled.
N O T E : Refer to the other documentation accompanying your Aerotech equipment. Call your Aerotech
representative if there are any questions on system configuration.
The protective ground connection of the ABL1000WB provides motor frame ground protection only.
Additional grounding and safety precautions are required for applications requiring access to the stage while
it is energized. The System Integrator or qualified installer is responsible for determining and meeting all
safety and compliance requirements necessary for the integration of this stage into the final application.
D A N G E R : Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock or damage to the equipment.
W A R N I N G : The protective ground connection must be properly installed to minimize the
possibility of electric shock.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
C A U T I O N : The stage controller must provide over-current and over-speed protection. Failure
to do so may result in permanent damage to the motor and stage components.
22
ABL1000WB Hardware Manual
Chapter 3 www.aerotech.com