Table of Contents
Advertisement
ABL1000WB Hardware Manual
Chapter 3: Electrical Specifications and Installation
W A R N I N G : Electrical installation must be performed by properly qualified personnel.
Aerotech motion control systems are adjusted at the factory for optimum performance. When the
ABL1000WB is part of a complete Aerotech motion control system, setup usually involves connecting the
ABL1000WB to the appropriate drive chassis with the cables provided. Labels on the system components
usually indicate the appropriate connections.
If system level integration was purchased, an electrical drawing showing system interconnects has been
supplied with the system (separate from this documentation).
The electrical wiring from the motor and encoder are integrated at the factory. Refer to the sections that
follow for standard motor wiring and connector pinouts.
The stage and its carriage are protected from dangerous faults by an integral safety ground through the
stage's motor power cable.
W A R N I N G : Applications requiring access to the stage while it is energized will require
additional grounding and safeguards. The System Integrator or qualified installer is responsible
for determining and meeting all safety and compliance requirements necessary for the
integration of this stage into the final application.
D A N G E R : Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock or damage to the equipment.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
www.aerotech.com
Electrical Specifications and Installation
Chapter 3
21
Advertisement
Table of Contents
