5
Horizontal stabilizer
1. Instal the Elevators
1 1
<
Horizontal stabilizer
< Elevator >
2
● Grease up to the moving part of
the hinge.
● Do not allow grease to adhere to
the insertion part.
3
● Attach the rudder to the hinges
with Epoxy glue.
● Hinge
< Elevator >
! Attention to the axial
direction of the hinge.
! Epoxy adhesive should not
adhere to moving parts.
! Do not allow grease to adhere
to the insertion part.
Install it firmly so as not to come off by vibration or
wind pressure.
>
4
● Hinge
5
6
● Horn guide Also
apply Epoxy glue
on the back side.
● Horn guide
● After the adhesion has dried, pour a suitable amount
of Epoxy glue into the hinge hole of the Horizontal
stabilizer and insert Elevator into the wing.
No Clearance
! Epoxy adhesive should not
adhere to moving parts.
● Move the elevator after drying. Check that the
rudder is securely attached.
● Ruff up the bottom of the
control horn with sandpaper to
help the glue stick to the horn.
< Elevator bottom side >
● 2-Control horns
● Adhesive with
● Cut the film of horn
● Attach the Elevator servos and Control horns to
the other Horizontal stabilizer by the same work.
Clearance is needed.
Epoxy glue
guide attachment part
and peel off.
13