Electrolux EKK61500O User Manual page 27

GAS CONNECTION
Choose fixed connections or use a flexible
pipe in stainless steel in compliance with
the regulation in force. If you use flexible
metallic pipes, be careful they do not come
in touch with mobile parts or they are not
squeezed.
FLEXIBLE NONMETAL PIPES
CONNECTION
If it is possible to easily control the connec-
tion in its full area, you can use a flexible
pipe. The flexible pipe must be tightly at-
tached by clamps.
Installation: use the pipe holder. Always en-
gage the gasket. Then continue with the
gas connection. The flexible pipe is pre-
pared for apply when:
– it can not get hot more than room tem-
perature, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting
edges or corners;
– it can be easily examined in order to
check its condition.
The control of preservation of the flexible
pipe consists in checking that:
– it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
– the material is not hardened, but shows
its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
Once installation is complete,
check the perfect seal of every pipe
fitting, using a soapy solution, nev-
er a flame.
The gas supply ramp is on the rear side of
the control panel.
WARNING!
Before gas connection discon-
nect the mains plug from the
mains socket or switch off the
fuse in the fuse box. Close the
primary valve of the gas supply.
A B
A) Gas connection point (only one point is
applicable for appliance)
B) Gasket
C) Adjustable connection
D) Natural Gas pipe holder
E)
LPG pipe holder
The appliance is set to default gas,
to change the setting choose pipe
holder from the list. Always use the
gasket sealing
ADJUSTMENT TO DIFFERENT
TYPES OF GAS
WARNING!
Let only an authorized person do
the adjustment to different types of
gas.
This appliance is for operation with
natural gas.
With the correct injectors, you can
also operate it with liquid gas.
WARNING!
Before replacing the injectors,
make sure that the gas knobs are
in the Off position and disconnect
the appliance from the electrical
supply. Let the appliance cool off
fully. There is a risk of injury.
INJECTORS REPLACEMENT
1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ENGLISH 27
C
E D